125kHz Wiegand 34 RFID QR Code Reader
QR1E is an RFID QR code card reader for WAC2 (AVEA http wiegand access controller) or any wiegand input controller. Good for office access management, visitor access management, smart home or access control systems.
Please see our WAC2 http wiegand access controller information from https://avea.cc/wac2/
Specification - QR1E QR code RFID Reader
Working Voltage : |
DC 9 - 12V |
Current : |
100mA |
Working Temperature : |
0 to 50 ℃ |
Reading Speed : |
0.2 second |
Inter Reading Interval : |
0.5 second |
Output Format : |
Wiegand 34 |
QR Code Length : |
10 decimal digits |
RFID Card Type : |
EM-ID |
RFID Card Reading Distance : |
~3cm |
Dimensions : |
86mm x 86mm x 42mm |
Wire Connection
Wire connection:
VCC : DC12V
GND : GND
D0 : DATA0
D1 : DATA1
LED : LED indicate (active low)
BEEP : Sound (active low)
TX/R+ :do not connect
RX/R- :do not connect
SPK-,SPK+:not defined;
RJ45 :do not connect
micro-USB :do not connect
Note:
- Please do not connect the power to the SPK+ and SPK- ports;
- Re wiegand output, the QR code format should comply with the combination of hexadecimal number 0~F. Otherwise, the controller cannot receive the card data.
- The defaultQR code output is decimal number.
Installation
- Prepare a 86mm bottom case, two screws and a flat blade screwdriver.
- Inset the flat blade screwdriver to the front panel. Level toward the front panel as below:
- Dismantle the front panel.
- Fix the QR code reader to the 86mm bottom case with screws.
- Align the front panel to the buckle.
- Press the front panel to the buckle.